In-Wall TV Wire Concealment in Fullerton
TV Mounting Line Fullerton covers hiding TV wires inside the wall in Fullerton homes — in-wall rated power kits and HDMI runs through drywall, with plaster, masonry and shared walls ruled out — and a note on the surface alternative.
Bookings aren't open yet. Leave your name and number; your message is recorded, and you'll get one message when a local installer is available.
Illustration
What can go inside a wall
Only products rated for in-wall use go inside a wall. A standard power cord never does.
| Cable | In the wall? |
|---|---|
| Standard power cord | Never |
| In-wall rated power relocation kit | Yes |
| HDMI rated for in-wall use | Yes |
| A new outlet | Electrician work |
Which walls allow it
Drywall over wood studs is the easy case: openings are cut at the TV and the outlet, the cable is fished through the stud bays and the plates are patched. Plaster is harder, because cutting it leaves a repair that rarely matches, and masonry has no cavity at all. In condos and townhomes the wall between two homes is often a fire-rated separation wall, and cutting a recessed box or an in-wall run into it is not what anyone should do; the interior partition is the place for any in-wall work.
The power kit starts at an existing outlet
A rated kit has an inlet behind the TV and an outlet low on the wall, joined by in-wall rated cable. It plugs into the outlet already there. It does not add a circuit and it does not replace the electrician for a new outlet.
What the numbers show
- Inlet plate Behind the TV, so the set's own cord reaches it without showing.
- In-wall rated cable Built and listed for use inside a wall; a standard cord never goes there.
- Lower plate Sits where an outlet would, with a short cord and a plug.
- Existing outlet The kit takes its power here; a new outlet or circuit is electrician work.
- HDMI in the wall Only HDMI rated for in-wall use goes in the bay with the power kit.
The surface alternative
A slim raceway painted the wall color carries the same cables on the surface, with nothing cut. In a plaster house, a rental or a shared wall it is often the better answer. A raceway is a surface finish and not part of the in-wall add.
What the numbers show
- Raceway run A slim strip painted to match the wall carries the cables straight down.
- Cover Snaps on the room side after the cables are in, and takes paint.
- Base Fixed to the wall surface with small screws or an adhesive strip in a rental.
- Cables HDMI, optical and the power cord all sit in the channel; nothing goes into the wall.
- Existing outlet The raceway ends at the outlet already on the wall.
In-Wall Wire Concealment — common questions
How much does hiding wires cost in Fullerton?
About $95–$155 on top of the base range in the estimator, for a rated kit on a drywall wall.
Can wires be hidden in a plaster wall?
Technically yes, but the repair seldom matches the old finish, so a painted surface raceway is the usual choice.
Availability & price range
In-Wall Wire Concealment: check availability and price range
Bookings aren't open yet — answer a few quick questions about the TV and the wall and get a typical Fullerton price range right here. Typical Fullerton prices for one TV, labor only unless an option says otherwise. This is a market estimate, not a quote.